Cheaptool - Tools for the manual maintenance of heat exchangers
F/800 Manual pulling
A manual pulling tool recommended for minor maintenance operations, the F/800 allows easy removal of stubs from the tubesheet.
F/790 One revolution tube cutter
Low cost tube cutter, depth adjustable from 50.8 to 152.4 mm ( from 2" to 6" ). The F/790 has been designed for manual use with a spanner. Its operation is based upon the eccentricity of the blade.
F/791 Tube reamers
Reaming bits in high speed steel with Morse taper shank and front guide tang with diameter adjusted to the BWG of the tube. For reducing the thickness of the walls of tubes to be replaced, for a depth equal to about 80% of the thickness of the sheet.
F/792 Toll for crumpling tubes
The collapsing tool model F/792 is used for crumpling tubes inside the tube sheet after the use of the tube reamer F/791. Generally used with the pneumatic hammer F/789.Cylindrical shaft: diameter 17,2 mm ( 0.677" ) x 60,3 mm ( 2.3/8" ).
F/793 Expelling tool
Tool that is used to push the stub out of the tube sheet, generally used with the pneumatic hammer F/789.Cylindrical shaft: diameter 17,2 mm ( 0.677" ) x 60,3 mm ( 2.3/8" ).
F/789 Pneumatic hammer
Pneumatic hammer specifically design for the tooling category "cheaptool"